Sanyo PLV-HD2000 - 7000 Lumens Manual page 30

PLV-HD2000 Expand Serial Command Functional Specifications
8.9.9. CF_P-MANE Command
Command "CF_P-MANE_%1" [CR]
"OFF" ----------------------------- Set Power management to OFF
%1 "READY" ------------------------- Set Power management to Ready
"SHUTDOWN" ----------------- Set Power management to Shut Down
Set/Cancel Power management (valid only when it is in the normal Power ON
status).
Details
The status set by this command is stored in EEPROM of the projector, so its
setting is effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
8.9.10. CF_P-MANETIME Command
Command "CF_P-MANETIME_%1" [CR]
"01" – "30" ---------------------- Directly specify time in minutes
%1 "UP" ----------------------------- Increment value by 1 (in minutes)
"DN" ----------------------------- Decrement value by 1 (in minutes)
Set Power management time (valid only when it is in the normal Power ON
status).
Details
The status set by this command is stored in EEPROM of the projector, so its
setting is effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
8.9.11. CF_FANSPEED Command
Command "CF_FANSPEED_%1" [CR]
"MAX" ---------------------------- Set to Maximum Fan Speed
%1
"NOR" ---------------------------- Set to Normal Fan Speed
Switch speed of Fan Control (valid only when it is in the normal Power ON status)
Details The status set by this command is stored in EEPROM of the projector, so its
setting is effective even after the power is turnedt to ALL OFF status.
Acceptable
Response
Unacceptable
8.9.12. CF_KEYDIS Command
Command "CF_KEYDIS_%1" [CR]
"NONE" ------------------------- Both RC and KEY are valid
%1 "RC" ------------------------------ RC is disabled
"KEY" ---------------------------- KEY is disabled
Set limitation of the use of RC and KEY
Details
(valid only when it is in the normal Power ON status)
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
30/56