Download Print this page

HP StorageWorks P2000 Installation Instructions page 2

Hp storageworks controller module installation instructions (590339-004, june 2010)
Hide thumbs Also See for StorageWorks P2000:

Advertisement

Enabling Partner Firmware Update
nl
(dual-controller configurations only)
In a dual-controller configuration, the Partner Firmware Update option
ensures that both controllers have the most recent version. HP
recommends enabling this feature.
To view or change the current Partner Firmware Update setting, select
the system in the navigation tree and then select Configuration >
Advanced Settings > Firmware. If needed, check the box and click Apply.
Removing the air management module
IMPORTANT:
Remove the air management module from the bottom bay only
when installing an optional second module.
1.
Turn the thumbscrews until the screws disengage from the module
(1) and rotate both latches downward to disengage the module
from the internal connector (2).
2.
Pull the module straight out of the enclosure (3).
NOTE:
For clarity, only relevant details are shown in this
illustration. Port and LED information is not included.
Installing the new module
IMPORTANT:
When installing modules in a new system, install the first module
in the top bay.
1.
With the latches in the open position, slide the module into the
enclosure as far as it will go (1). If necessary, press lightly on the
top-center of the module to facilitate insertion.
2.
Rotate the latches upward to engage the module with the internal
connector (2) and then, turn the thumbscrews finger-tight (3).
NOTE:
For clarity, only relevant details are shown in these
illustrations. Port and LED information is not included.
NOTE:
After installing a controller in an operational,
dual-controller system, the new controller automatically
begins to initialize. If the firmware versions differ
between the two controllers, Partner Firmware Upgrade
feature brings the older firmware to the later firmware
level.
3.
In operational systems, if additional hardware components, such
as a second controller, need replacing or installing, wait 30 minutes
before proceeding with those procedures. This time frame ensures
that the controller(s) and their ownership of vdisks are fully stabilized.
Page 2

Advertisement

loading