Asus P5KPL EPU User Manual page 34

5. IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 100/66 signal cable. There are three
connectors on each Ultra DMA 100/66 signal cable: blue, black, and gray. Connect the
blue connector to the motherboard's IDE connector, then select one of the following
modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the
same setting.
1-24
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
cable connector. This prevents incorrect insertion when you connect the IDE cable.
Mode of device(s) Cable connector
- Black
Master Black
Slave Gray
Master
Black or gray
Slave
Chapter 1: Product introduction