Buffalo AirStation WLI-H4-D1300 User Manual page 13

Chapter 2 Installation
3
Once your computer has booted, the AirStation's LEDs should be lit as described below:
Wireless
5 GHz
Buffalo
LAN
For LED locations, refer to chapter 1.
4
Press the WPS (or AOSS) button of the wireless router that you are currently using.
Note : This example explains how to make a one-touch connection between the AirStation and your wireless
router. To make the setting from the configuration interface of the AirStation, see Chapter 3.
5
Press the AOSS/WPS button on the AirStation until the wireless LED button on the front panel
starts flashing (about 1 second).
6
After about one minute, check that the Wireless LED on the AirStation's front panel is lit.
Note : If the Wireless LED continues flashing, connection with the wireless router has failed. Perform the
procedure again from Step 4.
7
Launch your web browser. If you can connect to the Internet, then setup is completed.
Note : If you cannot connect to the Internet, there may be a problem with the settings of your wireless router.
Refer to the manual for your wireless router for help configuring it.
On or blinking.
On or off.
White light on.
Green light on or blinking.
- 12 -