Use Lightning Arrester - TP-Link JetStream TL-SG3424 Installation Manual

L2 Managed Switch
212

Use Lightning Arrester

13
Lightning Protection
Power lightning arrester and signal lightning arrester are used for lighting protection.
Power lightning arrester is used for limiting the voltage surge due to a lightning. If an
outdoor AC power cord should be directly connected to the device, please use a power
lightning arrester.
Note: Power lightning arrester is not provided with our product. If needed, please self
purchase it.
Signal lightning arrester is used to protect RJ45 ports of the device from lightning.
When cabling outdoors, please install a signal lightning arrester before connecting the
cable to the device.
When purchasing or using a signal lightning arrester, please observe the following
rules:
The port rate of the signal lightning arrester should match the rate of the desired port
■
on the device. If it is not matched, this signal lighting arrester will not work. Purchase
a standard lightning arrester.
Install signal lightning arrester near the protected device and connect it to the
■
ground via a shorter ground cable.
Grounding Terminal
Signal Lightning Arrester
Figure 3-4
Note: Signal lightning arrester is not provided with our product. If needed, please self
purchase it.
Equipotential Bonding Cable Ethernet Cable
Device
Lightning Arrester Connection