Connections - Brother MFC-8220 User Manual

Do not connect a TAD elsewhere on the same phone line
(unless you have the Distinctive Ring service).
(Example for Australia)

Connections

The external TAD must be plugged into the back of the MFC, into the
socket labeled EXT. Your MFC cannot work properly if you plug the
TAD into a wall socket (unless you are using Distinctive Ring).
1
Plug the telephone line cord from the wall socket into the back
of the MFC, in the socket labeled LINE.
2
Plug the telephone line cord from your external TAD into the
back of the MFC, in the socket labeled EXT. (Make sure this
cord is connected to the TAD at the TAD's telephone line socket,
and not its telephone socket.)
3
Set your external TAD to four rings or less. (The MFC's Ring
Delay setting does not apply.)
4
Record the outgoing message on your external TAD.
5
Set the TAD to answer calls.
6
Set the Receive Mode to External TAD .
(See Choosing the Receive Mode on page 5-1.)
1 - 12 INTRODUCTION
TAD
TAD