Installing Rx0LE Flash and RAM
Step 2: Install the Rx0LE Flash Module
Warning
Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
1. To have easy access to the flash module, the PCI-e riser card must be removed first.
Using the finger tab, pull the card out of its connector and set aside.
Figure 8 Removing the PCI-e riser card
2. Note where the connector of the flash module is located in Figure 9. Use needle-nose
pliers to squeeze the plastic standoff lock as you rock the flash module back and forth
to remove it from the socket.
9