Control Panel; System Fans - Supero 1026T-6RF User Manual

S S
UPER ERVER 1026T-6RFT+/1026T-6F+ User's Manual
Figure 6-1. Chassis: Front and Rear Views
Power Supplies Dedicated IPMI LAN Port
Mouse/Keyboard Ports COM Port
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
6-3

System Fans

The SC119 chassis contains four counter-rotating fans. Each fan unit is actually
made up of two fans joined back-to-back, which rotate in opposite directions. This
counter-rotating action generates exceptional airfl ow and works to dampen vibra-
tion levels.
The SC119 chassis provides two additional open fan housings, where an additional
system fan may be added for optimal cooling.
Hard Drive Bays (8)
USB Ports PCI Expansion Slots (w/riser card)
VGA Port Gb Ports 10Gb/s Ports
6-2
Control Panel