Accessing The Drive Bays - Supero 1026T-6RF User Manual

Figure 6-3. Air Shroud Installation

Accessing the Drive Bays

Hard Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace the hard drives.
Proceed to the next section for instructions.
DVD-ROM Drive: For installing/removing a DVD-ROM drive, you will need to gain
access to the inside of the server by removing the top cover of the chassis. Proceed
to the "DVD-ROM Drive Installation" section later in this chapter for instructions.
Note: Only a "slim" DVD-ROM drive will fi t into the 1026T-6RFT+/1026T-6F+.
Warning! Enterprise level hard disk drives are recommended for use in
Supermicro chassis and servers. For information on recommended HDDs,
!
visit the Supermicro Web site at http://www.supermicro.com/products/nfo/
storage.cfm
Chapter 6: Advanced Chassis Setup
Screw
6-5
Notch