Make A Setup Floppy Disk - HP D5970A - NetServer - LCII Installation Manual

Chapter 4
another computer or network device. Typically, this wake-up
packet causes the adapter to signal the computer to power up
and run a pre-defined program.
See the Troubleshooting and FAQs section later in this guide
for general troubleshooting and a listing of common problems
and solutions for Wake on LAN operability.

Make a Setup Floppy Disk

If you need to use a floppy disk to install the adapter drivers,
use the MAKEDISK.BAT utility located in the ROOT directory
on the HP NetServer 10/100TX PCI LAN Adapter Drivers CD.
MAKEDISK [operating system] [destination]
where [operating system] is the OS for which you are creating
the diskette and [destination] is the drive letter and path (such
as A:).
The possible [operating system] options are:
W2K = Microsoft Windows 2000
NT = Microsoft Windows NT
NW = Novell NetWare servers and clients
OS2 = IBM OS/2
UTIL = DOS Diagnostics and information
10
Connecting the Network Cable