Setting Up Alb In Windows Nt 4.0; Deleting A Team; Setting Up Alb In Netware - HP D5970A - NetServer - LCII Installation Manual

Chapter 8

Setting up ALB in Windows NT 4.0

1. Double-click the Network icon in Control Panel.
2. On the Adapters tab, select an adapter that will be in the
team, and then click Properties. (Don't use an adapter that
is on a VLAN.)
3. In the HPSet window, click the Adapter Teaming tab.
4. Click the Add Adapter to a Team button.
5. The Teaming Wizard starts. Follow the wizard steps for
assigning adapters to a team. Note that you can specify a
Preferred Primary adapter, which in most cases will be
your highest bandwidth adapter. See the HPSet Help for
more information.
6. Click OK, then click Close to finish. When prompted,
restart your server.

Deleting a Team

1. Double-click the Network icon in Control Panel.
2. On the Adapters tab, select the ALB team to delete.
3. Click Remove. You'll see a confirmation dialog box. Click
Yes.
4. Click Close. Restart when prompted.
NOTE
When IPX is used, the frame type for each
adapter in the team reverts to Auto when a
team is deleted. You may need to set it to the
specific frame type to connect to your
network.

Setting up ALB in NetWare

To set up ALB in NetWare, use the instructions in the Setting
up Adapter Fault Tolerance in NetWare section earlier in this
guide, substituting "ALB" for the "Z" parameter.
34
Choosing Adapter Teaming Options