HP Z600 - Workstation - 6 GB RAM Installation Manual page 5

d. Lower the drive into the rails
e. Align the four pins on the rails with the holes in the hard drive, and then snap the rails into
place
Figure 3
4. To install the hard drive in the drive bracket, gently squeeze the green tabs
with rails into the bracket
Figure 4
5. Install the bracket in the workstation.
a. Disengage the optical bay release latch
ENWW
.
Installing the drive in the rails
.
2
Installing the drive in the ODD bracket
.
2
while inserting the bracket into the optical bay
Step 2—Installing the hard disk drive
while sliding the drive
.
2
5