Step 2-Installing The Graphics Card - HP Z200 - Small Form Factor Workstation Installation Manual

Pci express graphics card installation

Hide thumbs Also See for Z200 - Small Form Factor Workstation:

Step 2—Installing the graphics card

To install the graphics card:

NOTE:

If the computer has a card guide integrated into the chassis, omit the first step.

(Optional) If a card guide was included with the kit, lower it into the chassis and snap it into

place. The following figure shows two graphics card guide types.

Figure 2

If your computer requires a low profile card, replace the full-height bracket on the card with the

supplied low-profile bracket.

To install the PCIe graphics expansion card:

PCI Express graphics card installation

Installing the card guide (Optional)

If the PCIe graphics expansion card fits in a card guide, lower the card into the chassis and

align the card in the groove of the card guide.

NOTE:

For long cards, rotate the graphics card bulkhead under the rear chassis lip, and

then align the card extender with the card guide, while lowering it into the slot.

Figure 3

Aligning and installing a long graphics card

Verify that the keyed components of the card align with the slot (1).

Close the expansion slot retention clamp (2).

ENWW

Table of Contents