Step 2-Preparing For Component Installation; Removing Components - HP Xw6600 - Workstation - 2 GB RAM Installation Manual

Step 2—Preparing for component installation
CAUTION:
processor is installed.
NOTE: Workstation models vary. All illustrations are examples only.
Download and install updates
1. Check for available system BIOS updates specified for your HP workstation model and operating
system at http://www.hp.com/go/workstationsupport.
2. Install the system BIOS updates, if available.
Accessing the internal components of the workstation
1. If you need help preparing the workstation for this installation, consult the removal and replacement
procedures in the service guide for your workstation at
workstation_manuals.
NOTE:
Guide on the Documentation and Diagnostics CD that shipped with your workstation.
2. Power down the workstation, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the workstation.
4. Remove the side access panel.

Removing components

1. If present, remove the airflow guide to enable access to the system board.
2. If present, remove the memory fan assembly to enable access to the system board.
4 Second Intel® Xeon® processor installation
Failure to install the latest system BIOS might cause the workstation to fail when the new
For the HP Workstation series, these procedures are also available in the User
http://www.hp.com/support/
ENWW