HP Xw6600 - Workstation - 2 GB RAM Installation Manual page 5

Step 3—Installing the second processor
CAUTION:
— Installing a processor incorrectly can damage the system board. Contact an HP authorized reseller
or service provider to install the processor. If you plan to install the processor yourself, read all of the
instructions carefully before you begin.
— Failure to follow the workstation preparation instructions can result in an improperly installed
processor, causing extensive workstation damage.
— Processor socket pins are delicate and bend easily. Use extreme care when placing the processor
in the socket.
CAUTION:
(ESD) precautions while performing the system parts removal and replacement procedures:
— Work on a static-free mat.
— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body
to the ground.
— Create a common ground for the equipment you are working on by connecting the static-free mat,
static strap, and peripheral units to that piece of equipment.
Installing the second processor in the HP
1. To prepare the processor socket:
a. Raise the processor socket handle fully
b. Open the processor socket cover plate
c. Remove the processor socket protective cover
Figure 1
ENWW
Observe the following cautions when removing or replacing a processor:
To prevent damage to the workstation, observe the following Electrostatic Discharge
Opening the processor socket
Workstation series
.
.
2
.
Step 3—Installing the second processor 5