Warnings and cautions
WARNING!
of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce
the risk of injury from a hot component, enable the surface to cool before touching.
WARNING!
of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed
area marked with this symbol.
WARNING!
— Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
— Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.
— Disconnect power from the equipment by unplugging the power cord from the electrical outlet.
WARNING!
workstation setup, posture, health, and work habits for computer users, and provides important electrical
and mechanical safety information. This guide is located at
documentation CD (if one is included with the product).
WARNING!
be lifted by two persons to avoid personal injury due to product weight.
CAUTION:
beginning these procedures, be sure you discharge static electricity by briefly touching a grounded metal
object.
CAUTION:
— Installing a processor incorrectly can damage the system board. Contact an HP authorized reseller
or service provider to install the processor. If you plan to install the processor yourself, read all of the
instructions carefully before you begin.
— Failure to follow the workstation preparation instructions can result in an improperly installed
processor, causing extensive workstation damage.
— Processor socket pins are delicate and bend easily. Use extreme care when placing the processor
in the socket.
2
Diskette drive installation
Any surface or area of the equipment marked with this symbol indicates the presence
Any surface or area of the equipment marked with this symbol indicates the presence
To reduce the risk of electric shock or damage to your equipment:
To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper
If a product is shipped in packaging marked with this symbol,
Static electricity can damage the electronic components of the workstation. Before
Observe the following cautions when removing or replacing a processor:
http://www.hp.com/ergo
, the product must always
and on the
ENWW