HP Xw4600 - Workstation - 2 GB RAM Installation Manual page 6

Sata/sas hard drive and solid state drive

Hide thumbs Also See for Xw4600 - Workstation - 2 GB RAM:

Table of Contents

Slide the drive carrier firmly into the hard drive bay, rotating the handle to snap it closed.

Continue to

Step 3—Configuring the cabling

HP Z200 and Z400 Workstations and HP xw Workstations

NOTE:

HP Z200 Workstations do not support SAS hard drives.

If installing a SAS hard drive, attach the SAS-to-SATA interconnect cable adapter to the SAS

connector on the hard drive. The cable adapter is provided with the kit and is required only when

installing a SAS hard drive.

Figure 5

Select the SATA interconnect cable from the kit that best fits the hardware configuration of your

SATA or SAS hard drive. A cable with a right-angle connector can be used to avoid bending or

crushing the cable.

NOTE:

label, located inside the computer side access panel.

HP SATA/SAS hard drive and Solid State Drive installation

Step 3—Configuring the cabling on page 6

Install the SAS-to-SATA adapter

Individual SATA ports and connectors on the system board are identified on the service

ENWW

Table of Contents