HP Xw4600 - Workstation - 2 GB RAM Installation Manual page 4

Figure 1
3. Slide the hard drive into the selected bay until it snaps into place.
4. Continue to
HP xw6000, xw8000, and xw9000 series Workstations
1. Select an empty hard drive bay.
2. To remove the green rails from the empty bay, squeeze the green tabs and slide the rails out of
the bay.
3. To attach the rails to the hard drive:
a.
b.
c.
Figure 2
Workstations
4. Push the drive into the bay until it snaps into place.
5. Continue to
HP Z600 and Z800 Workstations
1. If a card support interferes with access to the system board connectors, remove it.
4 HP SATA/SAS hard drive and Solid State Drive installation
Installing the guide screws for HP Z200 and Z400 and HP xw4000 series Workstations
Step 3—Configuring the cabling on page 6
Gently open the rails (1).
The connectors on the rear of the drive should face toward the tabs on the carrier rails.
Lower the drive into the rails (2).
Align the four carrier pins with the holes in the hard drive, and snap the rails into place (3).
Installing the hard drive in the rails for HP xw6000, xw8000, and xw9000 series
Step 3—Configuring the cabling on page 6
ENWW