HP Workstation xw4000 Hardware Installation page 4

3. Align the screw holes in the tray with the screw holes at the rear of the workstation
Figure 3
4. Use a T-15 Torx screwdriver to fasten the tray to the workstation with the two chassis screws saved
earlier.
Step 3—Mounting the workstation rack
1. Attach the rails to the rack. See the rail installation instructions in this kit.
2. Remove the adhesive backing from the back of the glide strips.
3. Apply a glide strip to the top surface of each rail.
Figure 4
4 Rack mount tray installation
Fastening the tray to the workstation
Applying glide strips
.
ENWW