Hp Laserjet 5Si Mopier Comments - HP Color LaserJet 5500 Technical Reference Manual

HP LaserJet 5Si
Mopier Comments
Specifying the
Output Bin
Stapling Documents
PJL commands are used to specify the destination bin and
control printer functions such as stapling and collating
multiple copies.
Documents are sent to specific output bins using the
@PJL SET OUTBIN command. The HP LaserJet 5Si
Mopier bin definitions are as follows:
Bin Description
Engine face-down bin
High Capacity Output (HCO)
face-up bin
Stapling bin (in mailbox mode) OPTIONALOUTBIN7
Stapling bin (in stacker or job-
separator modes)
First non-stapling bin in mail-
box mode (only bin in stacker
and job-separator modes)
Last non-stapling bin (bottom
bin in mailbox mode)
To staple a document, include the following PJL command
in the PJL header at the beginning of the job (see the
example on the following page):
@PJL SET FINISH=STAPLE
To staple the output using this command, the printer
automatically determines which bin is the stapling bin,
so the output bin does not need to be specified using the
@PJL SET OUTBIN command. The printer uses the EOJ
command to determine the end of job so that the job can be
stapled correctly.
Note
Future printers may enable stapling using a different
command sequence.
OUTBIN Variable Name
UPPER
OPTIONALOUTBIN1
OPTIONALOUTBIN3
OPTIONALOUTBIN2
OPTIONALOUTBIN6
Feature Support A-41