Hp Laserjet 5Si/ 5Simx/5Si Mopier Comments - HP Color LaserJet 5500 Technical Reference Manual

HP LaserJet 5Si/
5SiMx/5Si Mopier
Comments
A-40 Feature Support
HP LaserJet 5Si, 5SiMx, and 5Si Mopier printers have
several features that differentiate them from most of the
other LaserJet printers. The following features should be
kept in mind when writing PJL code for these printers.
Three standard paper input sources are provided (two
500-sheet paper cassettes and a 100-sheet multi-purpose
tray).
Input selection can be controlled by selecting a media
type rather than a particular input tray—this feature is
controlled using PCL, instead of PJL, but it may affect
the manner in which PJL code is written (see the PCL 5
Comparison Guide for more information concerning this
feature).
Jobs may be canceled using the printer control panel. If
unsolicited status is enabled when jobs are canceled, the
printer responds with a status message (see the "Job
Cancellation" section in Chapter 5 for more information).
A PCL and PostScript-supported disk accessory is
available for storing information such as fonts and
macros. Chapter 9 describes the PJL file system that
manages the files on the printer disk.
The default symbol set is PC-8 instead of Roman-8.
The LaserJet 5Si and 5Si Mx printers have a top
(correct-order) output tray, holding 500 pages, and a side
(100-sheet face-up) output tray.
The LaserJet 5Si Mopier printer has a top (correct-order)
output tray, holding 500 pages, a side (100-sheet face-up)
output tray, a multi-bin mailbox (5 bins) and a stapler
bin. (See the following page for instructions on stapling
or collating documents.)