HP Color LaserJet 5500 Technical Reference Manual page 130

FILESYS Category
Example: Using the
INFO FILESYS
Command
@PJL INFO FILESYS [2 TABLE]
VOLUME TOTAL SIZE
0: 1755136
@PJL INFO FILESYS [1 TABLE]
VOLUME TOTAL SIZE
<FF>
7-22 Status Readback Commands
The INFO FILESYS command returns the following
information for each volume intialized on the PJL file
system:
Total capacity
Free space
Location
<ESC>%-12345X@PJL <CR><LF>
@PJL COMMENT Using @PJL INFO FILESYS <CR><LF>
@PJL ECHO 11:33:42.3 9-20-96 <CR><LF>
@PJL INFO FILESYS <CR><LF>
<ESC>%-12345X
A sample HP LaserJet 5 printer response for this example
is shown below. Other printers may respond differently.
FREE SPACE LOCATION LABEL
1718272 <HT>
If the mass storage device is not present (but the file
system firmware is), or if there are not initialized volumes,
the reply will be as follows:
FREE SPACE LOCATION LABEL
A printer with no file system firmware will treat this
command as a PJL INFO command with an unknown
category and will respond with the reply:
@PJL INFO FILESYS<CR><LF>
"?"<CR><LF>
<FF>
Volume label
Volume read/write status
STATUS<CR><LF>
<HT> READ-WRITE<CR><LF>
STATUS<CR><LF>