HP Vectra XA 5/xxx User Manual page 37

NOTE
The following table explains which connectors you should use when
you install additional devices.
Configuration
1 Hard Disk Drive 1. Bootable hard disk drive:
2 Hard Disk Drives 1. Bootable hard disk drive:
2. Second hard disk drive:
3 Hard Disk Drives 1. Bootable hard disk drive:
2. Second hard disk drive:
3. Third hard disk drive:
4 Hard Disk Drives 1. Bootable hard disk drive:
2. Second hard disk drive:
3. Third hard disk drive:
4. Fourth hard disk drive:
When connecting hard disk drives, note that if the drives are connected
to the same data cable, and the drives operate in different modes (or
speeds), the slower speed will be used. To avoid possible degradation of
disk performance, it is recommended that, whenever possible, hard disk
drives are placed on different cables.
There are two different types of connectors—these are shown below.
Some of the power connectors will already be connected to devices. If
you install a device that requires a different connector, the connector
converter should be supplied with the device.
2 How to Install Accessories In Your PC
Installing Mass Storage Devices
Connections to Data Cables
First connector, Primary IDE Cable
First connector, Primary IDE Cable
Second connector, Primary IDE Cable
First connector, Primary IDE Cable
Second connector, Primary IDE Cable
Secondary IDE Drive Cable Connector
First connector, Primary IDE Cable
Second connector, Primary IDE CableCD-
Secondary IDE Drive Cable Connector
Secondary IDE Drive Cable Connector
Power Cables for Hard Disk
Drives, Tape Drives, and CD-
ROM Drives
Power Cable for 3.5-inch
Flexible Disk Drive
English 27