HP Vectra VL800 Installation Manual page 8

Connecting to a Novell NetWare 5.1 or 4.11 Server
Microsoft Windows 98 2
Requirements
Operating System
Driver Version
Driver File
Server OS
Client OS
Procedure
1. With the HP Vectra turned off, install the network adapter into an available PCI
slot.
2. Connect the network cables to the newly installed network adapter.
3. Power on the machine and boot to Windows.
4. Windows will detect the network adapter as "Intel(R) PRO/100+ Dual Port Server
Adapter" during start up and automatically install its embedded driver.
5. Click on "Yes" when prompted to restart the system.
6. If the NetBEUI protocol is used, two error messages will appear indicating a
duplicate computer name exists on the network. The NetBEUI protocol is utilized
for each port of the network adapter and registers the computer name twice in the
same workgroup. In Windows, computers can not have the same name within a
workgroup. Ignore these error messages temporarily by clicking on OK.
7. If NetBEUI is necessary, make sure that it is used only on one port of the network
adapter. Open the Network properties and under the Configuration tab, select the
NetBEUI Protocol and remove it by clicking on the Remove button.
8. Additional changes in the network properties, such as: workgroup name,
computer name, TCP/IP properties, etc. may be necessary. Ask your Network
Administrator for more information. After changes are made, a restart will be
necessary.
9. From the location of the "Novell Client v3.30 for Windows 95/98" installation files,
execute "Setup.exe".
10. Click on "Yes" to accept the "Novell Terms and Conditions".
11. Select either "Typical" or "Custom" and click on "Install". Typical Installation is
normally chosen. Select Custom Installation only if you are an administrator or an
nd
edition
nd
Windows 98 2 edition
3.37.07.0000 (Embedded in OS)
E100BNT.SYS
NetWare 5.1 or 4.11 Server
Client v3.30 for Windows 95/98