HP Vectra VL800 Installation Manual page 12

Connecting to a Novell NetWare 5.1 or 4.11 Server
Microsoft Windows 2000 Professional
Requirements
Operating System
Driver Version
Driver File
Server OS
Client OS
Procedure
1. With the HP Vectra turned off, install the network adapter into an available PCI
slot.
2. Connect the network cables to the newly installed network adapter.
3. Power on the machine and boot to Windows.
4. Logon to Windows with administrator privileges.
5. Windows will detect the network adapter as "Intel(R) PRO/100+ Dual Port Server
Adapter" during start up and automatically install its embedded driver.
6. Ignore the error message that appears indicating a duplicate name exists on the
network. This is due to fact that the network card has two ports and Windows
2000 installs the NetBEUI protocol by default. The installation of the NetBEUI
protocol for each port registers the computer name twice in the same workgroup.
In Windows, computers can not have the same name within a workgroup.
7. If NetBEUI is necessary, make sure that it is used only on one port of the network
adapter. Note that the second port is detected as "Intel(R) PRO/100+ Dual Port
Server Adapter #2". Open the "Local Area Connection" properties of one of the
ports of the network adapter. Under the General tab, select the NetBEUI Protocol
and uncheck it.
8. Additional changes in the System or Local Area Connection properties, such as:
workgroup name, computer name, TCP/IP properties, etc. may be necessary.
Ask your Network Administrator for more information. After changes are made, a
restart may be necessary.
9. From the location of the "Novell Client v4.80 for Windows NT/2000" installation
files, execute "SETUPNW.EXE".
10. Click on "Yes" to accept the "Novell Terms and Conditions".
Windows 2000 Professional
4.2.27.0 (Embedded in OS)
E100BNT5.SYS
NetWare 5.1 or 4.11 Server
Client v4.80 for Windows NT/2000