Removing And Replacing The Battery - HP vc4820T - Thin Client Troubleshooting Manual

If you install a USB mouse and a USB keyboard in the secure USB compartment, route the cables
around and through the clips, then out the secure cable routing slot, as shown in the following illustration.
Figure 2-7

Removing and Replacing the Battery

Before beginning the replacement process, review
on page 8 for procedures you should follow before and after installing or replacing hardware.
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1. Locate the battery on the system board.
14 Chapter 2 Hardware Changes
Using the secure cable routing slot
Before removing the side access panel, ensure that the thin client is turned off and the
General Hardware Installation Sequence