Setup Utility-Power Management Setup; Setup Utility-Utility Task Actions - HP vc4820T - Thin Client Troubleshooting Manual

Setup Utility—Power Management Setup
Table 3-6 Setup Utility—Power Management Setup
Option
PWRON After PWR-
Fail
Wake on PME
BIOS Wake up
Day of Week
Time of Day
Setup Utility—Utility Task Actions
Table 3-7 Setup (F10) Utility Task Actions
Heading
Load Factory Defaults
Set Administrator Password
Set User Password
Save & Exit Setup
Exit without Saving
Description
When power is lost and comes back, the option determines what power state the system should go
to. Options are Off, On, and Former-Sts. Default is Former-Sts.
Enable/disable system wakeup capability for OnBoard LAN device and PCI card. Default is enabled.
Enable RTC alarm wakeup. Default is disabled.
Select the alarm RTC wakeup day of Sunday through Saturday.
Select the alarm RTC wakeup time of day (hh:mm).
Table
Select Yes or No (Y/N)
Allows you to set, change, and disable the administrator password.
Allows you to set, change, and disable the user password.
NOTE: When the user password is set, it prevents unauthorized access to the user's
setup. User password provides read-only access to Setup options.
Saves data to CMOS, then exit the Setup Utility.
Exit the Setup Utility without saving any changes.
Using the BIOS Settings 29