HP TouchSmart 300-1000 - Desktop PC Installation Manual page 3

Installing the VESA Adapter
Installing the VESA
Adapter Assembly
Assembly (continued)
(continued)
6.
Secure the VESA
top bracket to the
VESA bracket base
using the four 8-mm
(0.3-inch) screws
provided.
7.
100 mm
Be sure the third-
party wall-mounting
device (sold
A A B A B A A
separately) that you
plan to use with
the TouchSmart300
supports the
100 mm required VESA
standard 100mm
(3.9 inches) x
A B A B A
100mm (3.9 inches)
hole pattern (holes
marked with "B"),
designed for flat
panel displays
ranging in size from
508mm (20 inches)
to 582mm (22.9
inches) diagonal,
and weighing up to
22.7 kg (50 lbs).
To install the
computer leg inserts
before wall-mount-
ing the computer,
see "Installing the
Leg Inserts."
© Copyright 2009 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
*585922-B22* statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical and editorial errors or omissions contained herein.
585922-B22 Second Edition: November 2009
Installing the Leg Inserts
Installing the Leg
Inserts (All Models)
(All Models)
NOTE: HP
TouchSmart 600 and
HP TouchSmart
9100 models
shown below.
1.
Remove the screws
from the computer
legs, and then re-
move the legs.
2.
Install the leg inserts
and secure with the
two 8-mm (0.3-inch)
screws provided.
The computer is
now ready to be
wall-mounted. Fol-
low the hardware
manufacturer's
instructions on how
to wall-mount the
computer.