S2 Night Mode; S3 Default; Information - Denon DHT-589BA Owner's Manual

ENGLISH
S2 Night Mode
Optimized setting for late-night listening.
Set the dynamic range compression of the output audio.
[Selectable items]
OFF
: Turn night mode off.
Low
: Low setting.
Mid
: Middle setting.
High
: High setting.
Operating from the remote control unit
[NIGHT]
Press .
OFF Low
High
NOTE
When the "Dynamic EQ" setting is "ON" , setting is not possible.
When the "Dynamic Volume" setting is "ON" , setting is not possible.
S3 Default
Resets the settings to the default values.
[Selectable items]
Yes
: Reset.
No
: Do not reset.

For details on adjusting individual parameters, see "Adjusting the Parameters" (vpage 29).

Information

Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<STATUS>
Mid
Information on the main unit's various settings (Status) and on input
signals (Audio Input Signal) is shown on the display.
The information displayed changes each time you press
The information is displayed for several seconds before the display
BUTTON
returns to its original condition.
<BUTTON>
[BUTTON]
[Items to be checked]
• Surround Mode
• Input signal
• Dialogue normalization
• Input function
• Input digital terminal
• Audio Delay
• Tone Control
• Channel level of each speaker
• Cinema EQ
• Night Mode
etc.
Dialogue normalization function
This is automatically activated when playing Dolby Digital sources.
This function automatically corrects the standard signal level for
individual program sources.
The correction value can be checked using
O F F S E T
The figure is the correction value when the standard level is
corrected.
• The items displayed will differ depending upon the current settings,
the presence or absence of an input signal or the type of input signal,
etc.
• For details of the content of the items displayed, refer to the page
containing an explanation of the settings.
<STATUS>
.
<STATUS>
.
- 4 d B