Configuring Startup Devices - IBM NetVista A40 User Manual

After you change an option and restart the computer, the following screen
might appear.
The following error(s) were detected when the system was started:
162 Configuration Change Has Occurred
Select one of the following:
Continue
Exit Setup
Note: Depending on the configuration changes that occurred, the error
message you see might be different from the one shown here. If the
preceding screen appears, select Continue until you reach the program
menu (see "Chapter 4. Using the Configuration/Setup Utility program"
on page 29).
If the preceding screen does not appear, use the program to configure your
computer. For more information, see "Chapter 4. Using the
Configuration/Setup Utility program" on page 29.

Configuring startup devices

When your computer is turned on, it looks for an operating system. The order
in which it searches devices for the operating system is the startup sequence.
After adding new devices to the computer, you might want to change the
startup sequence. You can use the program to configure startup devices. See
"Changing the primary startup sequence" on page 38.
POST Startup Error(s)
Chapter 5. Installing options
69