IBM NetVista A40 User Manual page 28

User guide for netvista 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648, and 6649 systems (english)
Hide thumbs Also See for NetVista A40:
Table of Contents

Advertisement

1. If your computer is the desktop model, check the position of the
voltage-selection switch. Use a ballpoint pen to slide the switch, if
necessary.
v If the voltage supply range is 90–137 V ac, set the voltage switch to 115
V.
v If the voltage supply range is 180–265 V ac, set the voltage switch to 230
V.
2. Connect the monitor cable to the monitor (if it is not already attached), then
to the monitor connector and tighten the attachment screws.
Note: If your computer comes with an accelerated graphics port (AGP)
adapter, the monitor connector on the system board will be disabled.
Connect the monitor to the AGP monitor connector.
3. Connect the keyboard cable to the purple keyboard connector. Connect the
mouse cable to the green mouse connector.
Note: If your computer comes with Windows NT and a ScrollPoint
mouse, the first time you start up your computer, your mouse will
function, but your mouse will not have its ScrollPoint function. You
must shut down and restart the computer to enable the ScrollPoint
function.
4. Connect any additional devices you have.
v Any printer or parallel device to the parallel port connector.
v Any serial device or external modem in the serial connector.
v Any universal serial bus (USB) devices.
v Any optional devices, such as speakers, microphones, or headphones, for
models with an audio device.
v If there is a label covering the power connector, remove it. Connect the
power cords to the computer, monitor, and other devices first, and then
plug the cords into properly grounded electrical outlets.
v If your computer comes with an Ethernet adapter, connect the Ethernet
cable.
10
User Guide
Voltage Switch
115
II

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents