Reassembling The Pc - Compaq Presario S7000 - Desktop PC Manual

to install an expansion card
1 If you are replacing or adding a new expansion
card, in either the S0000 or 8000 series, align the
edge of the expansion card with the slot on the
chassis and gently, but firmly, press the card
straight down into the expansion slot. The whole
connector should be seated properly in the
expansion slot.
replacing or adding an expansion card on the
S0000/8000 (S0000 shown)
•
If you have an 8000 series, continue to step 2.
•
If you have an S0000 series, skip to step 3.
2 For the 8000 series, secure the expansion card to
the chassis with the slot cover screw.
3 For both the S0000 and 8000 series, if you have
replaced an expansion card, store the old card in
the anti-static packaging that contained your new
card.
•
If you have an S0000 series, continue to step 4.
•
If you have an 8000 series, skip to step 5.
4 For the S0000 series, replace the expansion cover
bracket (1) and screw (2).
10
upgrading and servicing the pc
replacing the expansion bracket cover on the
S0000 series
5 For both the S0000 and 8000 series, complete the
procedure described in "reassembling the pc" on
page 10.

reassembling the pc

1 Replace the front bezel by following the method
appropriate for your PC model.
•
To replace the front bezel on the S0000 series,
position the chassis in the upright position. At
an angle, align the top of the front bezel with
the top slots of the chassis (1) so that the front
bezel hooks onto the chassis, and then press the
bottom end of the bezel to the chassis until it
snaps into place (2).
replacing the front bezel on the S0000 series
1
2