Replacing Or Adding A Drive - Compaq Presario S7000 - Desktop PC Manual

1
removing a hard disk drive from the 8000 series
5 For both the S0000 and 8000 series, if you are
replacing the old drive with a new drive, remove
the four screws (4) (two on each side) from the old
drive. You need these screws to install the new
drive.
NOTE: If you have the S0000 series, and you
removed a 7-In-1 memory card reader, continue to
step 7; otherwise, you are finished with the task of
removing a drive from the chassis.
If you have the 8000 series, and you removed a
hard disk drive, a 7-In-1 memory card reader or an
optical drive, you are also finished with this
task. If you have the 8000 series, and you removed
a diskette drive, continue to step 6.
6 For an 8000 series diskette drive, squeeze inward
on both sides of the bracket brace, and lift the
brace up and out (1). Remove the two sets of
screws (2) (left and right sides) that secure the
drive to the drive adapter. Lift the diskette drive
out of the drive adapter (3) by sliding the drive
back and then up. Ensure that the guide screws (4)
(left and right sides) are left in the drive adapter.
You are finished with the task of removing the
drive.
4
3
2
2
2
removing a diskette drive from the drive
adapter on the 8000 series
7 For the S0000 series 7-In-1 memory card reader,
remove the reader from the drive bay adapter if
the adapter is not included with your replacement
reader. Remove the two screws (left and right
sides) that secure the reader to the adapter. Lift the
reader out of the adapter by sliding the reader
back and then up. You are finished with the task of
removing the reader.
removing a 7-In-1 memory card reader from the
drive bay adapter on the S0000 series

replacing or adding a drive

The steps to replace or add a drive are the same for
both the S0000 and 8000 series, except when you are
replacing a diskette drive on the 8000 series, or the
7-In-1 memory card reader on the S0000 series.
1
3
4
2
upgrading and servicing the pc
5