Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Compaq S6035IL
Summary of Contents for Compaq S6035IL
- Page 1 Compaq Presario Desktop Products Upgrading and Servicing Guide...
- Page 2 The information in this document is subject to change without notice. ® Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HP shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material.
-
Page 3: Table Of Contents
table of contents safety information... 1 opening and closing the pc... 1 removing and replacing drives... 3 adding memory ... 6 removing or installing an add-in card ... 7 replacing the battery... 8 preparing the pc...1 before opening the pc ...1 after closing the pc ...2 removing the side panel ...2 replacing the side panel ...2... - Page 4 Upgrading and Servicing Guide...
-
Page 5: Safety Information
It will be easier to consult this information than to open up and examine the PC. • Compaq recommends that you use an antistatic wrist strap and a conductive foam pad when working on the system. WARNING: Always disconnect the modem... -
Page 6: After Closing The Pc
after closing the pc To avoid injury and equipment damage, always follow this procedure in this order after closing the PC. 1 Reconnect the power cord. WARNING: To reduce the risk of electrical shock, fire, or damage to the equipment, do not plug telecommunications or telephone connectors into the network interface card (NIC) (labeled as an... -
Page 7: Replacing The Front Panel
replacing the front panel 1 Align the top of the front panel with the top of the chassis front. 2 Press the panel onto the chassis at the top and at each side near the bottom until the panel snaps into place. -
Page 8: Replacing Or Adding A Drive
3 Release the drive from the chassis by lifting the tab (1) on the latch drive bracket, and then sliding (2) the drive partway out of the bay. (The latch drive bracket secures the drives in their respective positions in the chassis.) 4 Disconnect the power cable (1) and data cable (2) from the back of the drive you want to remove, as indicated in the following illustrations. - Page 9 3 Make sure the jumper on the new optical drive or hard drive is in the CS (Cable Select) position. Your drive may vary from the illustration. cable select jumper 4 Install four guide screws on the sides of the new drive (two on each side).
-
Page 10: Adding Memory
adding memory Your PC comes with random access memory (RAM), which temporarily stores data and instructions on your PC. The PC ships with one or more memory modules, but you can replace the existing memory module(s) with higher-capacity ones. The motherboard contains sockets for DDR DIMMs (double data rate dual in-line memory modules). -
Page 11: Removing Or Installing An Add-In Card
2 The memory module can be installed in only one way. Match the notch on the module with the tab on the memory socket (B). Push the module carefully and firmly into the slot, ensuring that the latches on both ends snap into place. 3 Set the chassis upright. -
Page 12: Installing An Add-In Card
6 If you are not replacing the old add-in card with a new add-in card, close the open slot by inserting the metal slot cover into the opened slot. installing an add-in card 1 Align the edge of the add-in card with the slot on the chassis and gently but firmly press the card straight down into the add-in card slot.