Epson WorkForce AL-M200DN User Manual page 86

2. Select Admin Menu, and then press the
3. Select Network, and then press the
4. Select Wi-Fi Setup, and then press the
5. Select the desired access point, and then press the
If the desired access point does not appear:
a Select Manual Setup, and then press the
b Enter the SSID, and then press the
Use the or
cursor.
c Select Ad-hoc, and then press the
d Select an encryption type, and then press the
Important:
Be sure to use one of the supported encryption methods to protect your network traffic.
6. Enter the WEP key, and then press the
Use the or button to enter the desired value, and press the
7. Select a transmit key.
8. Wait a few minutes until the printer restarts to establish the wireless network.
9. Print a System Settings page from the operator panel.
See "Printing and Checking the System Settings Page" on page 34.
10. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
Note:
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
button.
button.
button.
button.
button to enter the desired value, and press the
button.
button.
AL-M200 Series
button.
button.
or
button.
or button to move a cursor.
Printer Connection and Software Installation
User's Guide
button to move a
86