Verifying The Ip Settings - Epson WorkForce AL-M200DN User Manual

Note:
The window to select a printer appears in this step when multiple print drivers are installed on your
computer. In this case, click the name of the desired printer listed in Printer Name.
The Printer Setting Utility starts.
2. Click the Printer Maintenance tab.
3. Select TCP/IP Settings from the list at the left side of the page.
The TCP/IP Settings page is displayed.
4. Select Panel from IP Address Mode, and then enter the values in IP Address, Subnet Mask, and
Gateway Address.
5. Click the Restart printer to apply new settings button to take effect.
The IP address is assigned to your printer. To verify the setting, display the web browser on any
computer connected to the network and enter the IP address into the address bar on the browser. If the
IP address is set up correctly, EpsonNet Config appears on your browser.
You can also assign the IP address to the printer when installing the print drivers with installer. When
you use the network installation feature, and the Get IP Address is set to DHCP or DHCP/AutoIP on
the operator panel menus, you can set the IP address from 0.0.0.0 to the desired IP address on the
printer selection window.

Verifying the IP Settings

The following procedure uses Windows 7 as an example.
Note:
The reports and lists are all printed in English.
1. Print the System Settings page.
2. Look under the IPv4 heading on the System Settings page to ensure that the IP address, subnet
mask, and gateway address are appropriate.
To verify if the printer is active on the network, run the ping command in your computer:
1. Click Start, and select Search programs and files.
AL-M200 Series
Printer Connection and Software Installation
User's Guide
33