Kyocera Ecosys FS-C8650DN Operation Manual page 332

Maximum number of sheets available for manual stapling
A4, A4-R, B5, Letter, 16K
A3, B4, Folio
Use the buttons on the stapling control section of the Finisher (optional) for manual stapling.
Stapling position
lamps
1
Press the stapling position key on the stapling control section.
The shutter of the paper exit area is opened and this equipment enters into the manual staple mode.
2
Press the stapling position key to select the stapling position (Back
Operation is not possible while the stapling position lamps are blinking. Operate after the lamps light solidly.
3
Straighten the edges of the paper well and place the paper front side
down in the shutter opening of the output unit.
If the near side of the paper (
the front guide (A).
If the far side of the paper (
the back guide (B).
If the edge of the paper (
paper with the center aligned to the center point between the two side
guides (A and B).
CAUTION Do not insert your hand inside the open shutter.
Note Press the stapling position key before you place the paper. Once the paper is placed, the stapling position
key cannot be used.
The stapling lamp lights when the paper is properly placed. If it does not light, replace the paper.
4
Let go of the paper, and then press the stapling key.
Stapling starts. Stapling finishes and the output is delivered to tray A.
CAUTION Be sure that your hands are away from the paper while stapling is in progress.
Finishing the manual staple mode
Press the stapling position button several times until the stapling position lamps turn off. The shutter of the paper exit
area closes. It means that manual stapling is finished. If no operation is performed for approx. 10 seconds, the manual
staple mode will be automatically finished.
Note The time after which manual staple mode is automatically exited can be changed. For details, refer to Manual
Staple (Manual Staple setting) on page 6-77.
Paper size
Stapling position
key
) will be stapled, place the paper against
) will be stapled, place the paper against
) will be stapled at two points, place the
Paper weight
2
- 90 g/m
( - 24.0 lb. Bond)
65 sheets
30 sheets
Stapling
key / lamp
/ Front
A-4
2
91 - 105 g/m
(24.3 - 28.0 lb. Bond)
50 sheets
30 sheets
/ 2 Points ).
B
A
Appendix