Personal Memory Plus Function; Last Function Memory; Backup Memory; Resetting The Microprocessor - Denon AVR 4308CI - AV Network Receiver Owner's Manual

<DSP SIMULATION>
<STANDARD>
<POWER>


Personal Memory Plus Function

This function sets the settings (input mode, surround
mode, etc.) last selected for the individual input sources.
When you switch to an input source, the settings are
automatically set to the ones that were set the last time
that input source was used.
The surround parameters, tone control, room EQ settings and the
volumes of the different speakers are stored for the individual surround
modes.

Last Function Memory

This stores the settings as they were directly before the
standby mode was set.
When the power is turned back on, the settings are
restored to as they were directly before the standby mode
was set.

Backup Memory

The various settings are backed up for about 1 week,
even if the power is turned off or the power cord is
disconnected.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if
operations cannot be performed.
When the microprocessor is reset, all the settings are
reset to their default values.
1
<POWER>
Turn off the power using
2
<POWER>
Press while simultaneously pressing
STANDARD
< > <DSP SIMULATION>
and
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
.
.