Error Messages; Parameter Check - Denon AVR 4308CI - AV Network Receiver Owner's Manual

Error Messages

If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error
message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform
the auto setup procedure over again.
Error messages (examples)
No microphone or speaker • Included setup microphone is not connected.
• Not all speakers could be detected.
Ambient noise is too high • Too much noise in the room for accurate
or Level is too low measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
None • Displayed speaker could not be detected.
· The front L and front R speakers were not
properly detected.
· Only one channel of the surround (A) and
surround (B) speakers was detected.
· Sound was output from the R channel when only
one surround back speaker was connected.
· The surround back or the surround (B) speaker
was detected, but the surround (A) speaker
was not detected.
• Displayed speaker connected with the polarities
Phase
reversed.
Select "Retry" to make the measurements again.
NOTE Be sure to turn the power off before checking the speaker connections.

Cause
• Connect the included setup microphone to the SETUP MIC
jack on the main unit.
• Check the speaker connections.
• Either turn off any device generating noise or move it
away.
• Try again when the surroundings are quieter.
• Check the speaker installation and the direction in which
the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may be displayed
even if the speaker is properly connected. If you are sure
that the wiring is correct, select "Skip" .
s Option
Select settings for room EQ, mic, etc.
Room EQ
Measures
Select room EQ setting method.
[Selectable items]
Direct Mode
Select room EQ use for DIRECT or PURE DIRECT mode.
[Selectable items]
Mic Select
Select the microphone type if not using supplied mic.
The microphone connected to V.AUX Lch is used.
[Selectable items]
Only a professionally certified installer should ever connect a
professionally-calibrated microphone to the V.AUX L input on the front
panel.
d Parameter Check
Check auto setup measurement results.
This is displayed after the auto setup procedure
is completed.
[Items to be checked]
The auto setup results can be reset to what was originally calculated
by MultEQ XT when "Restore" is selected.
All Assign
ON OFF
Mic V.AUX L
Spkr Config Check Distance Check
Ch. Level Check Crossover Check
EQ Check