Denon AVR 4308CI - AV Network Receiver Owner's Manual page 36

e U se the ui p button to input the address and press the
button.
IP Address :
Set the IP address within the ranges shown below. The Network
Audio function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask :
When connecting an xDSL modem or terminal adapter directly
to the AVR-4308CI, input the subnet mask indicated in the
documentation supplied by your provider. Normally input
255.255.255.0.
Default Gateway :
When connected to a gateway (router), input its IP address.
Primary DNS Secondary DNS :
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at "Primary DNS". If there are
two or more DNS addresses, input the first one at "Secondary
DNS".
r U se the i button to select "Exit" and press the
Setup is complete.
b
When connecting to the network via a Proxy server, select "Proxy"
ENTER
and press the button (vpage 35 "Proxy settings").

Wireless LAN settings
ENTER
Use this procedure to configure the Wireless LAN settings.
1
Fitting a rod antenna (vpage 20).
b If a LAN cable is connected, remove it.
2
Turn on the AVR-4308CI (vpage 49).
3
Set the access point at the GUI menu "Manual Setup"
– "Network Setup" – "Network Setup".
When searching access points to connect automatically, refer to
"Automatic settings".
When searching access points to connect manually, refer to
"Manual settings".
n Automatic settings
ENTER
button.
q S elect "Search" and press the
The access point you have set is displayed.
w U se the ui button to select the access point, and then press
ENTER
the button.
q Select "Search".
w S elect the access point.
Example) DENON
ENTER
button.
b If the access points are not detected automatically, use the i
button to select the "Manual" and press the
Setting becomes manual. For details, see "Manual settings"
(vpage 34, 35).
Select when access
points cannot be searched
automatically.
b If the access points are repeat search, use the i button to select
ENTER
the "Search" and press the button.
Select when searching
access points again.
e I f there is an encryption setting for the access point you selected
in step w, enter same encryption key as used for the access
point. (If there is no encryption setting, proceed to step t.
r S et only during
"WEP" in step w.
t Select "Connection".
ENTER
button.
e Enter
encryption key.