Table of Contents
Advertisement
h Trigger Out 1
Select the conditions to turn on the trigger out 1 with
respect to the zone, input source, surround mode, HDMI
monitor, etc.
For details about the trigger out function, see page 21.
j Trigger Out 2
This sets the conditions to turn on the trigger out 2, in the
same way as "Trigger Out 1" above.
ON
– – –
[Selectable items]
Setting with Respect to the Zone
• When the power of the zone turned on/off, the trigger out turns on.
• Associated with the power supply of zones set to "ON" .
Setting with Respect to the Input Source
• When the input source set to on is selected, the trigger out turns
on.
• Associated with respect to the input source for zones set to "ON" at
"Setting with Respect to the Zone" .
Setting with Respect to the Surround Mode
• When the surround mode set to on is selected, the trigger out turns
on.
• Associated with respect to surround modes that are set to "ON" .
• This can be set if the "MAIN ZONE" setting at "Setting with Respect
to the Zone" is set to "ON" .
• Associated when an input source for which "Setting with Respect to
the Input Source" is set to "ON" is selected.
Setting with Respect to the Monitor
• When the HDMI monitor set to on is selected, the trigger out turns
on.
• Associated with respect to HDMI monitor that are set to "ON" .
• This can be set if the "MAIN ZONE" setting at "Setting with Respect
to the Zone" is set to "ON" .
• Associated when an input source for which "Setting with Respect to
the Input Source" is set to "ON" is selected.
k Digital Out
Set usage of OPT3 OUT.
[Selectable items] ZONE4 Select Rec Select
NOTE
The ZONE4 operations cannot be performed when set to "Rec
Select" .
l Remote ID
Set remote control ID.
Match the ID setting of the remote control unit and the
receiver.
[Selectable items] 1
2
3
4
• When changing the remote ID, also change the "AMP" , "iPod" , "TU"
and NET/DTU modes of the main remote control unit at the same
time (vpage 64).
• When changing the remote ID, also change the sub remote control
unit at the same time (vpage 69).
A0 2Way Remote
Make setting for 2-way remote control unit.
[Selectable items] Used
Not Used
When using a 2-way remote control unit (RC-7000CI and RC-7001RCI,
sold separately), set this to "Used" .
A1 Dimmer
Adjust display brightness of the receiver.
[Selectable items]
Bright
Dim
Dark OFF
Operating from the main unit
Press the DIMMER button.
Bright
Dim
OFF
Dark
A2 Setup Lock
Protect settings from inadvertent change.
[Selectable items]
ON
OFF
• When "Setup Lock" is set to "ON" , the settings listed below can
no longer be changed. Also, "SETUP LOCKED!" is displayed if you
attempt to operate related buttons.
⋅ GUI menu operations
⋅ RESTORER
⋅ Night Mode
⋅ Parameter
⋅ Room EQ
⋅ Channel Level
⋅ Audio Delay
⋅ Video Format / GUI Language
• To cancel the setting, press the MENU button to re-display the "Setup
Lock" screen, then change the setting to "OFF" .
A3 Maintenance Mode
This sets the function for maintenance by a DENON
serviceperson or installer. (For professional use only.)
This function allows a DENON serviceperson or installer to check the
AVR-4308CI's status and make settings via the Internet.
NOTE
Only use this function if so instructed by a DENON serviceperson or
installer.
36
Advertisement
Table of Contents
