Personal Memory Plus Function; Last Function Memory; Backup Memory; Panel Lock Mode - Denon AVR 4308 - Sony Bravia 40" TV Owner's Manual

Personal Memory Plus Function

This function sets the settings (input mode, surround
mode, etc.) last selected for the individual input sources.
When you switch to an input source, the settings are
automatically set to the ones that were set the last time
that input source was used.
The surround parameters, tone adjustment, room EQ settings and
the volumes of the different speakers are stored for the individual
surround modes.

Last Function Memory

This stores the settings as they were directly before the
standby mode was set.
When the power is turned back on, the settings are
restored to as they were directly before the standby mode
was set.

Backup Memory

The various settings are backed up for about 1 week,
even if the power is turned off or the power cord is
disconnected.

Panel Lock Mode

The buttons on the main unit can be locked if not using
them.
Locking operation of all the main unit buttons
When this is set, none of the buttons on the main unit can be used.
1
<POWER>
Turn off the power using
2
<POWER>
Press while simultaneously pressing
SIMULATION> <ZONE2 ON/OFF>
and
To operate <MASTER VOLUME> only
1
<POWER>
Turn off the power using
2
<POWER>
Press while simultaneously pressing
<DIRECT/STEREO> <ZONE2 ON/OFF>
and
Perform the operation below to cancel the setting.
q Press <POWER>.
w Press <POWER> while simultaneously pressing <PURE DIRECT> and
<ZONE2 ON/OFF>.

Remote Lock Mode

This setting can be made so that the remote control unit
cannot operate the AVR-4308CI, for example when not
using it, etc.
1
Turn off the power using
.
2
<POWER>
Press
<STATUS>
and
<DSP "Remote Lock" appears on the display.
.
To cancel, perform the same operation as above.
.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if
operations cannot be performed.
When the microprocessor is reset, all the settings are
.
reset to their default values.
1
Turn off the power using
2
<POWER>
Press
STANDARD
<
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
<POWER>
.
while simultaneously pressing
<ENTER>
.
<POWER>
.
while simultaneously pressing
> <DSP SIMULATION>
and .
60