Connecting The Control Terminal; Connecting The Trigger Out Terminals; Connecting The Multi Zone Terminals; Zone2 (Or Zone3) Pre-Out Connections - Denon AVR-3806 Operating Instructions Manual

Connecting Other Sources

Connecting the CONTROL terminal

Connecting the TRIGGER OUT terminals

This terminal is used for an external
controller.
Perform the following operation
before using an external controller
connected to the RS-232C terminal:
1. Press the ON/STANDBY switch
on the main unit and set the unit
to the operating mode.
2. Perform the operation to turn off
the power from the external
control.
3. Check that the product has been
set to the standby mode.
After checking the above, check the
connections of the external
controller. Operation is possible.
Turn the DC 12V voltage on and off
for the individual functions and
surround modes.
For details, see "Setting the Trigger
Out" ( page 71).
22
ENGLISH

Connecting the MULTI ZONE terminals

For instructions on operations using the MULTI ZONE functions (

ZONE2 (or ZONE3) pre-out connections

• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 pre-out
(variable) and ZONE3 pre-out (fixed level) terminals can be used to play a different program
source in ZONE2 (or ZONE3) the same time (
• The ZONE2 video out is only for the ZONE2.
Extension terminal
for future use.
NOTE:
• For the AUDIO output, use high quality pin-plug cables and wire in such a way that there is no
humming or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices'
operating instructions.
ENGLISH
Connecting Other Sources
page 54~56).
page 54).
Monitor TV
(ZONE2)
G
VIDEO
IN
H
S VIDEO
IN
Power amplifier
(ZONE2)
Premain amplifier
(ZONE3)
A
L
L L
IN
R R
R
INPUT OUTPUT
+ +
AUX OUT
INFRARED INFRARED
RETRANSMITTER SENSOR