Table of Contents
Advertisement
Auto Setup
Optimize settings for speakers in use.
F Menu tree F
Auto Setup
a Auto Setup
s Option
d Parameter
a Auto Setup
The settings are performed automatically.
GAuto setup fl owH
STEP1: Speaker Detect
STEP2: Measurements (2 to 8 positions)
STEP3: Calculation
STEP4: Check
STEP5: Store
Start
Start auto setup and output the test tone.
Set as desired before starting the auto setup procedure.
If an error message appears during the measurements, check "Error
messages" , take the necessary countermeasures, then redo the
measurements (vpage 27).
Confi guration
The speaker system to be measured can be selected ahead of time
here.
7.1 (B)
7.1 5.1
[Selectable items]
Setting the speaker confi guration reduces the time required to analyze
the speakers during the auto setup procedure.
Amp Assign
Advanced setting : changes power amplifi er assignment.
NOTE
The items selectable at "Confi g. " differ according to the "Amp Assign"
settings.
STEP1 : Speaker Detect
The speaker connection status and the speaker polarities are detected at
the main listening position. At this time, the listening environment with
respect to the main listening position ("Speaker size check" , "Distance
correction" , "Channel level adjustment" , "Crossover frequency check"
and "Room EQ correction") is measured automatically at the main
listening position.
Once the measurements are completed, the results of the speaker
connection are displayed.
NOTE
• Loud test tones are output during the measurements. Be careful
when measuring at night or when there are small children nearby.
• Do not stand between the speakers and setup microphone or allow
obstacles between them while the measurements are being made.
Obstacles will make it impossible to measure correctly.
• Keep as quiet as possible during measurements. Loud sounds in the
area will make it impossible to measure correctly.
• Operating the MASTER VOLUME knob on the main unit or the VOL
+/– buttons on the remote control unit during the measurements will
cancel the measurements.
• Do not change the speaker connections or subwoofer volume after
"STEP1" .
STEP2: Measurements
The listening environment with respect to the listening position
("Speaker size check" , "Crossover Frequency check" and "Room EQ
correction") is measured automatically at positions 2 to 8.
Once a measurement is made, move the setup microphone to the
next position.
Measure a total of at least 6 positions (main listening position and at
least 5 other surrounding positions). Measurements can be completed
even if only taken in 5 positions, but for better results we recommend
taking them in 6 or more positions. (Measurements can be taken in
a maximum of 8 positions.)
STEP3: Calculation
When "Calculate" is selected at "STEP2" , the speaker system is
analyzed automatically.
The time required for this analysis depends on the number of speakers
connected. The more the number of speakers, the longer the time
required for analysis.
STEP4: Check
Once the auto setup procedure is completed, a measuring result
checking screen appears.
Select any item whose measuring results you want to check and check
the results.
Values that are different from the actual distance may be set for
speakers with built-in fi lters (subwoofers, etc.).
STEP5: Store
The auto setup measurement results are stored.
NOTE
Do not turn the power off while the settings are being stored in the
memory.
Advertisement
Table of Contents
