Table of Contents
Advertisement
Turn on power by pressing the power button on the monitor. If the system is not
A
powered up, check if the main power switch is in the 'on' position.
Main Power Switch
Turn on the PC.
B
Select an input signal.
Press the Input Select button on the remote controller to select the input signal.
Or, press the SOURCE button at the front side of the monitor.
When connecting with a DVI-D signal input cable.
A
• Select DVI DIGITAL: DVI-D digital signal.
B
When connecting with a D-Sub signal input cable.
• Select DSUB ANALOG: 15-pin D-Sub analog signal
How to connect to two computers.
Note
Connect the signal cables (DVI and D-Sub) to each computer.
Press the Input Select button in a remote controller to select the computer to use.
Directly connect to a grounded power outlet on the wall or a power bar with a ground
wire.
DVI DIGITAL
DSUB ANALOG
VIDEO1(CVBS)
VIDEO2(S-Video)
SCART 1
SCART 2
[Case 1]
A12
Power button
DVI DIGITAL
DSUB ANALOG
VIDEO1(CVBS)
VIDEO2(S-Video)
COMPONENT 1
COMPONENT 2
[Case 2]
Advertisement
Table of Contents
