Assembling And Hanging The Fan - Hunter 28420 Installation & Operation Manual

3 • Assembling and Hanging the Fan
Steps 3-1 – 3-2
Adapter
Steps 3-3 – 3-4
Low Profile Washer
6
#8-32 x 1" Screw
Hunter Fan Company
You can assemble your fan for standard mounting (steps 3-1 – 3-2)
or for low profile mounting (steps 3-3 – 3-4). Note: For low profile
mounting, the downrod is replaced with the low profile washer.
Downrod
3-1. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
Canopy
wires from the fan through the downrod.
3-2. Screw the downrod into the fan assembly. Tighten the allen head
Canopy
set screw using the included allen wrench. Skip to Step 3-5.
Trim Ring
CAUTION: e downrod has a special coating on the threads.
Allen Head
Do not remove this coating; the coating prevents the downrod from
Set Screw
unscrewing. Once assembled, do not remove the downrod.
3-3. To assemble the fan to hang from a low ceiling, place the low
profile washer (lip up) into the canopy. Be sure the green ground
wire is pointing up toward the ceiling.
3-4. Align the holes in the washer with the holes in the adapter.
Assemble securely with three #8-32 x 1" screws.
3-5. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim. Go to 4 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Step 3-5
U-shaped
Hole
41842-01 • 04/28/05