Brushroll - Hoover UH70400 Owner's Manual

hose
: how to Clean
To reduce the risk of injury from moving parts, unplug vacuum before servicing.
4.10 To remove hose for tool use, press the hose release button (A) and pull
hose end out.
Clear away debris or obstructions from hose. Do not use sharp objects to clean
out hose as they can cause damage. To lock back into place, push hose into
hose tube until you hear a click.
CYCloniC filter asseMblY
CAUTION
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
Do not use vacuum without dirt cup or filters
in place.
Remove dirt cup as described in Fig. 4.2.
4.11 Lift the filter assembly (A) up out of the dirt cup.
4.12 Dirt and debris can be cleaned from the filter
assembly with the dusting/ upholstery tool.
4.13 Place the filter assembly (A) on the dirt cup,
aligning the D-shaped tab on the top of the dirt cup.
Press down firmly to place the filter assembly back
in place.
Replace dirt cup as described in Fig. 4.4.

brushroll

: how to Clean
CAUTION
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
4.14 Turn vacuum over so bottom side is facing up.
Remove any debris and/or hair from brushroll.
For additional maintenance required for belt or
brushroll please contact a HOOVER
provider at 1-800-944-9200.
4.15 Vacuum is equipped with an automatic
brushroll shut off. A red flashing light (A) will indicate
a jammed brushroll. To reset the brushroll, press
the reset button (B) located on the side of your
vacuum. If the light continues to flash red after
resetting, the brushroll may still be blocked. Check
for obstructions in the brushroll area and remove
any obstructions. Press the brushroll reset button to
ensure the blockage is fully cleared.
CAUTION
!
: how to Clean
!
!
®
service
!
4.11
A
4.14
11
4.10
A
4.12
4.13
A
4.15
A
b