Cleaning The Brushroll; Solución De Problemas - Hoover Presto 2-in-1 Owner's Manual

cleaninG the brushroll

CAUTION
! !
To reduce the risk of injury from moving parts,
remove hand vac before cleaning or servicing.
3.5 Use a coin to rotate the locking button (A).
3.6 Remove the cover (B), take the brushroll (C) out
and clean out any debris or obstructions. (Do not
clean in water).
Assemble the brushroll back into place and ensure
it fits properly. Place cover back into place, and use
coin to rotate the locking button back to original
position.
4. troubleshootinG
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped in water,
take it to a service center prior to continuing use.
WARNING
!
To reduce risk of personal injury - turn vacuum off before servicing.
probleM possible cause
Cleaner won't
1. Battery not charged.
run
2. Battery dead - won't hold a
charge.
3. Needs service.
Hand Vac will
1. Handvac not turned off before
not run charging.
Cleaner won't 1. Dirt Cup not installed correctly.
pick-up or
low
2. Dirt cup is full.
suction
3. Battery charge is getting weak.
4. Filter is dirty.
5. Clogged filter.
6. Nozzle/dirt passage clogged.
Dust
1. Dirt cup is full.
escaping
2. Dirt cup not installed correctly.
from cleaner
3. Filter not installed correctly.
Actual model may vary from images shown.
3.5 3.6
A b
!
possible solution
Charge battery for 18-24 hours prior to first use.
Fully deplete battery and allow to cool for 15
minutes before recharging on charging base.
Repeat two more times. After three uses, allow
12-16 hours to recharge the battery.
2. Visit hoover.com or call 1-800-944-9200 for
nearest authorized Hoover dealer.
®
3. Visit hoover.com or call 1-800-944-9200 for
nearest authorized Hoover dealer.
®
1. Push power button a second time to turn on.
1. Review Dirt Cup Removal and Cleaning
section pg. 9.
2. Empty dirt cup.
3. Charge battery.
4. Clean filter. If filter needs to be replaced,
replace filter.
5. Remove filter and clean.
6. Disconnect nozzle by pressing release button
(see section 1.5) and remove obstruction.
1. Empty dirt cup.
2. Review Dirt Cup Removal & Replacement.
3. Review Dirt Cup Removal & Replacement.
10
C