Regulatory Statements - HP Jetdirect 610n Hardware Installation Manual

Electromagnetic
FCC Title 47 CFR Part 15 Class A for Ethernet (Class B if
LocalTalk only) (USA)
ICES-003 Class A (Canada)
VCCI Class A (Japan)
AS/NZS3548 Class A (Australia, New Zealand)
CISPR-22 Class A (1993)* for Ethernet (Class B if LocalTalk
only) (International, Europe)
CNS 13438 Class A (Taiwan)
Korean EMI Law, No. 1996-98 Class A (Korea)
(*For EU immunity compliance, see the Declaration of Conformity
on page B-39.)
HP Jetdirect J4167A Token Ring Print Server: a DB-9 connector for
Type 1, 2, or 6 shielded twisted-pair cables is provided. Use shielded
cable for compliance with electromagnetic emission standards when
operating at 16 Mbps.

Regulatory Statements

FCC Statements
General Information. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this
equipment not expressly approved by the Hewlett-Packard Company may cause
interference and void the FCC authorization to operate this equipment.
The Federal Communications Commission has prepared a booklet titled
Interference Handbook (1986), which may be helpful to you. This booklet
(stock number 004-000-004505-7) may be purchased from the Superintendent
of Documents, U.S. Government Printing Office, Washington, D.C. 20402.
FCC Class A for HP J4167A Token Ring, and HP J3110A, J3111A, J4169A,
J6057A Ethernet or IEEE 802.3/802.3u. This equipment has been tested and
found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against
interference in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause interference to radio communications.
Installing this equipment in an FCC Level B product results in an FCC Level A
Composite System (as defined in the FCC Rules and Regulations) when attached
to an Ethernet (IEEE 802.3/802.3u) or Token Ring (IEEE 802.5) network.
B-38
ENWW