Ahci Configuration - Asus Maximus II Gene User Manual

3.4.�

AHCI Configuration

This menu is for AHCI configuration. It appears only when you set the Configure
SATA as item under SATA Configuration to [AHCI].
Main
AHCI Settings
AHCI CD/DVD Boot Time out
AHCI Port1 [Not Detected]
AHCI Port2 [Not Detected]
AHCI Port3 [Not Detected]
AHCI Port4 [Not Detected]
AHCI Port5 [Not Detected]
AHCI Port6 [Not Detected]
AHCI CD/DVD Boot Time out [15]
Selects the boot time out value for SATA CD/DVD devices in AHCI mode from the
following options: [0] [5] [10] [15] [20] [25] [30] [35]
AHCI Port1–6 [XXXX]
Displays the status of auto-detection of SATA devices.
Main
SATA Port1
Device :Not Detected
SATA Port1
SMART Monitoring
SATA Port1–6 [Auto]
[Auto]
[Not Installed]
SMART Monitoring [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor
system. When read/write of your hard disk errors occur, this feature allows
the hard disk to report warning messages during the POST.
[Enabled]
[Disabled]
ROG Maximus II GENE
BIOS SETUP UTILITY
[15]
BIOS SETUP UTILITY
[Auto]
[Enabled]
Allows automatic selection of the device type connected to
the system.
Select this option if no SATA devices are installed.
Enable the SMART monitoring feature.
Disable the SMART monitoring feature.
Some SATA CD/DVD in
AHCI mode need to
wait ready longer.
Select the type of
devices connected to
the system.
3-21